Back to results

Virginia Tech

Effects of selected factors on sawmill residue wood chip quality

Abstract

dc:description.abstract

This study examined the effects of disk speed, temperature and anvil condition on chip size from sawmill residues of Loblolly pine (<i>Pinus taeda</i> L.). Objectives were: 1) to document the effects of disk speed, temperature and anvil condition on the amount of over thick, oversize, accept, pin and fine chips produced from edgings, 6"x6" cants and trim blocks and 2) to recommend changes in processing sawmill residues to minimize the production of over thick, pin and fine chips. Ten trials were conducted at the Chesapeake Corporation's West Point, Virginia hardwood sawmill using a Fulghum Industries 60-in. (152-cm) diameter, six-knife, vertical disk chipper. Tests were conducted at approximately 80, 70, 60, 50 and 40% of the full disk speed of 707 rpm for the three material types. It was found that decreasing disk speed decreases the amount of pin and fine chips and increases the amount of over thick chips for all material types. The maximum amount of accept and oversize chips was obtained at 50% disk speed. If 50% efficient secondary processing of the over thick chips is achieved, the maximum amount of oversize and accept chips would be produced at 40% disk speed. All frozen and chilled residue types tended to produce less oversize chips and significantly more pins and fines than wood at ambient temperature. A worn anvil caused a significant increase in pins and fines while causing a significant decrease in oversize chips from the cants. Design changes are suggested to reduce the amount of over thick chips produced by vertical disk chippers.

Degree

thesis:*
Name thesis:degree_name
Master of Science
Level thesis:degree_level
masters
Discipline thesis:degree_discipline
Agricultural Engineering
Department dc:contributor.department
Agricultural Engineering
Grantor dc:publisher
Virginia Tech
Year dc:date.issued
1992

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Edelman, John S.
Chairs dc:contributor.committeechair
  • Stuart, William B.
  • Perumpral, John V.
Committee member dc:contributor.committeemember
  • Haugh, C. Gene

Rights

dc:rights
Statement dc:rights
  • In Copyright
Language dc:language.iso
en

Identifiers

dc:identifier.*
Dc Identifier Other
etd-03302010-020129
OAI identifier oai:identifier
oai:vtechworks.lib.vt.edu:10919/41810

Chain of custody

source
Harvested from
Virginia Tech
Base URL
vtechworks.lib.vt.edu/oai/request
Last updated
2026-07-22
Source record
OAI-PMH GetRecord
related terms
citation

Edelman, John S.. Effects of selected factors on sawmill residue wood chip quality. masters thesis, Virginia Tech, 1992. http://hdl.handle.net/10919/41810