Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 825 for “"loadings"”.

  1. Nutrient Loadings Into Conesus Lake

    … the results of measurements for stream nutrient loadings, effects of the Inlet wetland on nutrient dynamics and road salt loadings. N0 3 -N loading upstream of the Conesus Inlet Wetland that was consistently about 2.5 times higher than downstream suggests nitrogen removal by denitrification in …

    brockport Repository record for Nutrient Loadings Into Conesus Lake (opens in a new tab)

  2. Aesthetic pollutant loadings in upstream combined sewers.

    An improvement to the standard of discharges from combined sewer overflows is necessary to meet the challenges set by the EC Urban Waste Water Treatment Directive (1991). To prevent aesthetic pollutants being discharged from a CSO, it is first necessary to gain an understanding of the quantity and …

    sheffield-hallam Repository record for Aesthetic pollutant loadings in upstream combined sewers. (opens in a new tab)

  3. Pore-water pressure accumulation under dynamic loadings

    The primary objective of this dissertation is to study the impact of closely spaced low-magnitude earthquakes or other dynamic events on the stability of upstream raised tailings dam. For this purpose, a series of numerical analyses were conducted and the level of excess pore-water pressure …

    uiuc Repository record for Pore-water pressure accumulation under dynamic loadings (opens in a new tab)

  4. The Fatigue of Weldments Subjected to Complex Loadings

    Cruciform and double-strap lap weldments were fatigue tested under constant amplitude axial load and SAE Bracket Spectrum load conditions. For the cruciform weldments, fatigue cracks generally initiate at the root but may initiated the toe if higher bending stresses are induced by joint distortion. …

    uiuc Repository record for The Fatigue of Weldments Subjected to Complex Loadings (opens in a new tab)

  5. Comparing the responses of nitrifiers to differing ammonia loadings

    Return active sludge from the Danville Sanitary plant (Danville, IL) was fed 10 mg NH3-N/L per cycle of separated swine manure to allow the biomass to adapt to a new influent in a sequencing batch reactor. The biomass was then separated into three reactors. A control reactor was exposed to 10 mg …

    uiuc Repository record for Comparing the responses of nitrifiers to differing ammonia loadings (opens in a new tab)

  6. Estimating Bacterial Loadings to Surface Waters from Agricultural Watersheds

    Fecal bacteria and pathogens are a major source of surface water impairment. In Virginia alone, approximately 73% of impaired waters are impaired due to fecal coliforms (FC). Because bacteria are a significant cause of water body impairment and existing bacterial models are predominantly based upon …

    vt Repository record for Estimating Bacterial Loadings to Surface Waters from Agricultural Watersheds (opens in a new tab)

  7. Modeling the hydrologic and particulate loadings from paved urban surfaces

    This dissertation details the results of recent investigations concerning non-colloidal particulate matter found in urban rainfall-runoff and urban snowmelt. Three forms of the power law model (PLM) were used to model particle number density. It was found that significant model error could be …

    lsu-thes Repository record for Modeling the hydrologic and particulate loadings from paved urban surfaces (opens in a new tab)

  8. Optimum Design of Composite Wing Spar Subjected to Fatigue Loadings

    <p>Composites are now being incorporated into aircraft designs because of their high strength to weight ratio compared to traditional metal materials. Due to the complexity of the material, composite parts are presently being over designed to satisfy static and fatigue requirements. A greater …

    calpoly Repository record for Optimum Design of Composite Wing Spar Subjected to Fatigue Loadings (opens in a new tab)

  9. The Effects of Pattern Loadings on Reinforced Concrete Floor Slabs

    Made available in DSpace on 2014-12-08T23:55:57Z (GMT). No. of bitstreams: 1 6406087.pdf: 5012080 bytes, checksum: ecec32fcb558fa6ed0c9a0d176911917 (MD5) Previous issue date: 1963

    uiuc Repository record for The Effects of Pattern Loadings on Reinforced Concrete Floor Slabs (opens in a new tab)

  10. Crush behavior of flanged plates under localized in-plane loadings

    Thesis (Ph. D.)--Massachusetts Institute of Technology, Dept. of Ocean Engineering, 1996.

    mit Repository record for Crush behavior of flanged plates under localized in-plane loadings (opens in a new tab)

  11. Behavior of pressure confined concrete in monotonic and cyclic loadings

    Thesis (Ph. D.)--Massachusetts Institute of Technology, Dept. of Civil Engineering, 1987.

    mit Repository record for Behavior of pressure confined concrete in monotonic and cyclic loadings (opens in a new tab)

  12. A study of the effects of differential loadings on cofferdams

    Conventional design of cellular cofferdams is largely based upon semi-empirical concepts derived from classical earth pressure theories. Recent studies have suggested that most existing design methods are excessively conservative. In part, this derives from an inability to fully describe the true, …

    vt Repository record for A study of the effects of differential loadings on cofferdams (opens in a new tab)

  13. The response of a suction anchor group to various applied loadings.

    The results of a study of the behaviour of buried suction anchors tested singly and in a group arrangement are presented and discussed. The tests were conducted in saturated granular soil, contained in a 1.8 m diameter tank, in both loose and dense states. The model anchors and the test apparatus …

    rgu Repository record for The response of a suction anchor group to various applied loadings. (opens in a new tab)

  14. Vertical Displacements of Spread Footings on Clay: Static and Impulsive Loadings

    Made available in DSpace on 2015-05-12T21:40:30Z (GMT). No. of bitstreams: 2 license.txt: 4848 bytes, checksum: 96035ab3f5e1c23cc7138a224ce498bd (MD5) 6406032.PDF: 6584774 bytes, checksum: 6bc5cb67a9c22102757b0a8eb5ecd084 (MD5) Previous issue date: 1963

    uiuc Repository record for Vertical Displacements of Spread Footings on Clay: Static and Impulsive Loadings (opens in a new tab)

  15. Procedure to Quantify Environmental Risk of Nutrient Loadings to Surface Waters

    … to quantify environmental risk of nutrient loadings to surface waters and to demonstrate the procedure on a watershed. A procedure to quantify environmental risk of nutrient loadings to surface waters was developed. The risk is identified as the probability of occurrence of a nonpoint source …

    vt Repository record for Procedure to Quantify Environmental Risk of Nutrient Loadings to Surface Waters (opens in a new tab)

  16. Vibrations of and sound radiation from some periodic structures under convected loadings

    … cylindrical shells excited by random convected loadings. The sound power radiated under these conditions is also dealt with. The stiffened structures are represented by uniform beams, plates or shells on periodically spaced elastic supports which represent stiffener-skin interaction forces and …

    soton Repository record for Vibrations of and sound radiation from some periodic structures under convected loadings (opens in a new tab)

  17. Behavior of Continuous Beams on Elastic Foundations Under Different Conditions of Loadings

    Made available in DSpace on 2014-12-08T23:56:08Z (GMT). No. of bitstreams: 1 6408396.pdf: 19368150 bytes, checksum: 877200ce43e5ac428818c5e2af7aaaed (MD5) Previous issue date: 1964

    uiuc Repository record for Behavior of Continuous Beams on Elastic Foundations Under Different Conditions of Loadings (opens in a new tab)

  18. Response of grooved composites to transversely distributed and localized spherical contact loadings

    The response of a grooved composite specimen to two contact loading situations is studied; load applied via a transversely oriented cylindrical indenter and via a localized spherical ball-ended indenter. The philosophy of the Building Block Approach is used to develop these tests in the current …

    mit Repository record for Response of grooved composites to transversely distributed and localized spherical contact loadings (opens in a new tab)

Page 1 of 42