Emissions and operational aspects of methanol as an alternative fuel in a stationary gas turbine

During this research techniques have been developed to measure the lubricating properties of methanol and various additives. Suitable lubricant additives were found to improve methanol's lubricity to equal that of aviation kerosene, with as little as 1% additive. The lower heating value of methanol required modifications to the WVU gas turbine's fuel system and atomizer, to provide higher flow rate of fuel then required with aviation kerosene. The gas turbine was modified and operated on methanol for an extended period, without failure. Exhaust gas emissions were tested for carbon monoxide (CO), carbon dioxide (CO2), oxides of nitrogen (NOx), total hydrocarbons (HC), and particulate matter (PM). During operation on methanol significant reductions in NOx and HC emissions were observed. Without significant change in turbine inlet temperature, this observation can only be explained by a significant reduction in primary combustion zone peak temperature. Combustion completion with methanol must then extend into the secondary dilution air zone. Start-up at idle and even at low bleed air power levels, proved to be impossible on methanol. At these low power levels, engine flame-out was experienced during fuel change over from aviation kerosene to methanol. (Abstract shortened by UMI.).

Name thesis:degree_name

MS

Level thesis:degree_level

Thesis

Discipline thesis:degree_discipline

Mechanical and Aerospace Engineering

Year dc:date.available

2000

Author dc:creator

• Guiler, Richard William

Contributors dc:contributor

• John Loth.

• Aerospace engineering
• Chemical engineering
• Mechanical engineering
• Energy

Identifier

https://researchrepository.wvu.edu/etd/1004

OAI identifier oai:identifier

oai:researchrepository.wvu.edu:etd-2007